LCC options greyed out after upgrading to C1v.7
I am working through an older session file created in version 6 and I wanted to take advantage of the better C1 7 conversion. Though I upgraded the session files to version 7 but I dont get the Dust removal to work anymore.
I imported the LCC library file data from v. 6 as advised in the C1 help files and under "creating LCC options" both Dust removal" and "Technical Lens correction Data " are included and applied . Some of the the "Enable Uniform Light" option came back but all of my "Dust Removal" can't be clicked anymore.
Even recreating the LCC 's do not work.
what am I missing?
FYI: files are taken with IQ180 , LCCs are properly exposed (not blown, centre right histogram). Session initially created in C1 6 (not sure exactly which iteration but assume last ) Now I am on C1 v. 7.1
The older session was overwritten, the folder though still holds both the .col50 and the .cosessiondb session files.
I exported some files into another session and there the LCC creation including Dust removal worked fine. I even tried the "Verify Session" under the file menu and all seemed OK.
any ideas how to make this session work again without exporting all images and start a new session and loosing my adjustments?
thanks
I imported the LCC library file data from v. 6 as advised in the C1 help files and under "creating LCC options" both Dust removal" and "Technical Lens correction Data " are included and applied . Some of the the "Enable Uniform Light" option came back but all of my "Dust Removal" can't be clicked anymore.
Even recreating the LCC 's do not work.
what am I missing?
FYI: files are taken with IQ180 , LCCs are properly exposed (not blown, centre right histogram). Session initially created in C1 6 (not sure exactly which iteration but assume last ) Now I am on C1 v. 7.1
The older session was overwritten, the folder though still holds both the .col50 and the .cosessiondb session files.
I exported some files into another session and there the LCC creation including Dust removal worked fine. I even tried the "Verify Session" under the file menu and all seemed OK.
any ideas how to make this session work again without exporting all images and start a new session and loosing my adjustments?
thanks
0
-
Please update to 7.1.1. This was corrected here. 0 -
Dear Christian,
greetings from Hong Kong & thanks for taking the time to reply.
The upgrade to 7.1.1 actually did not help.
But I found a work-around after noticing that my lens profile for all lenses after upgrading a C1 6 library to 7.1 were missing. Instead of "generic" it said "none"
FYI images were shot with Alpa Technical camera.
here is what I did that helped though very time consuming exercise:
1: created new Session file
2: imported all images with adjustments (I did not want to loose ratings and adjustments)
3: switched lens profile from "None" to Generic"
4: applied the missing LCC profile after the upgrade to all white card images (at this point I needed to close down C1 and reopen for the LCC to be recognised by C1, before the LCC badge did not show and therefore could not be applied to the images
5: applied LCC again
I think there is a bug that changed the lens profile to none which in turn prevented C1 to recognise the LCC. that info of somewhat lost after I upgraded the library.
My question now since I dont want to go through with this on all my older sessions if I decide to open them in C1 7 is how to deal with this to avoid this massive work and duplication of my session?
thx0 -
Seems connected to this
viewtopic.php?f=46&t=14187
Cheers, Bob0
Post ist für Kommentare geschlossen.
Kommentare
3 Kommentare