cap 4.0 displays

hi (first post )
just updated cap 3 to cap 4.0 to cater for 40D camera- no problem -all appears to work fine so far including batch processing /speed etc .Dont really miss the auto develops folder in cap 3 since before using cap 4.0 I create a main folder in MY PICTURES for the raw downloads say 40D RAW with a sub folder for the edits say 40D RAW DEVELOPS . I then copy raw files from card/reader to 40D RAW folder (and ext h/d ) then ( or at any time later )I can open cap4.0 select the 40D RAW folder -edit images and send to the 40D RAW DEVELOPS folder .The only problem I have so far is that the display headings are cut off at the bottom and only half of the curve display is shown [ ie-ELE shows FIF ] anyone experienced this ? - am told 4.1 should correct -maybe better to wait for 4.2/3/4 after reading 4.1 posts !!!!--YES ???
Why does phase one not detail such corrections for each update ? pity . Hope this is of interest to some users -look forward to any further advise/ comments /suggestions etc
brituc

scorpio

16. Juni 2008 12:40

[quote="brituc" wrote:
The only problem I have so far is that the display headings are cut off at the bottom and only half of the curve display is shown [ ie-ELE shows FIF ] anyone experienced this ?

It's a matter of screen-resolution. 1280x 800 is minimum.

Brian 6

16. Juni 2008 13:41

hi scorpio
sent several emails to phase one on this including a screen shot -resolution was one of their suggestions - tried all resolutions but did not solve the problem which was still there at all resolutions
the final comment from phase one was that ver 4.1 would correct it - have not updated yet for reasons stated and that ver 4.0 works ok so i suppose its not a major problem for me !! It would be nice have the full display though Thanks for your interest and quick reply
brituc

Kommentare