Zooming in issues
I'm having an issue when zooming in using the hot keys on Mac. While zooming in from a 100% image, I press command - twice, on the third command - click, the image goes back to 100%. Anyone else having this issue? I'm using the newest version of the Software. This issue did not happen in the previews versions I have used.
-
Yep I have the same issue, well not the same percentages but the zoom in/out on a Mac using the hot keys does not zoom out fully on a portrait image, but is fine on a landscape image. Like you on a portrait image, mine goes from 33% to 25% then jumps back up to 67% and just cycles round down to 25% and back up to 67% if I repeat the process with the hot kets, works fine with the mouse zoom or the slider at the top, bit annoying when its pack of the workflow you are used to!
0 -
I've noticed a similar issue since updating. With an image that is 8256 X 5504 and the long edge horizontal/landscape, if I start with the image at "Fit" (zoom slider all the way to the left) and use command + to zoom in, I have to press it four times before the image changes on screen. When I do this, the slider moves with each press even if the image doesn't change on screen. When the image does change on the fourth press, it goes from Fit to 50%. After reaching 50%, each press of command + seems to step up the zoom appropriately; 67%, 100%, 200% and etc. When I use command - to zoom out, the steps above 67% seem okay but it takes two presses of command - to get from 67% to 50% and then only one more to get from 50% back to the Fit level.
If the long edge is vertical/protrait, on the third press of command + the zoom switches from Fit to 33% and each press of command + after that seems to change it as it should. When zooming out with command - it takes two presses to go from 67% to 50% and two presses to go from 33% to Fit.
The images above were all from a Nikon D850 and in a newly created session. I also opened an older session with smaller images from a D7000, 4928 X 3264. It took six presses of command + to change the image on screen from the Fit level to another zoom level, 100%. That was with the long edge horizontal. With the long edge vertical, five presses moved it from Fit to 67% and in the opposite direction it took two presses to change the on screen image from 67% to Fit.
This is using version 14.3.0 on a 2019 iMac with a 5K 27-inch display and Radeon Pro Vega 48 8 GB graphics card.
0
Post ist für Kommentare geschlossen.
Kommentare
2 Kommentare