HDR problem with 16.2 and now 16.3 with Fuji GFX 100 II files

What problem do you see this solving?

HDR is completely unusable, the HDR previously created with C1 16.2 comes with a green cast when read with 16.3, the HDR created with 16.3 gets a hard redish cast! (Although thumbnails in C1 navigator are read correctly)

I have to add that in 16.2 HDR comes with a Tint over 50 (around 60 to 80)… Even if the result looks close to reality… But when I wanted to correct a bit to get a little less red, I just can't as C1 does not accept tint values over 50 when manually typed!

When was the last time you were affected by this lack of functionality, or specific tool?
Very badly, as an interior of boat/yachts and architecture photographer, shooting HDR is mandatory.

Are you using any workarounds or other solutions to achieve your goals in Capture One?
I did redo the hardware acceleration, did not help.
Disabled hardware acceleration in the pref, did not help either…

Mac Apple Studio M1Ultra / Ventura 13.4.1 / 64 ram Gb - Fuji GFX 100 II files

Are you happy to be contacted further about this suggestion or request?
“Yes”

Brian Jordan

25 de octubre de 2023 21:23
Editado

Apologies if I’ve posted this to you specifically. I’m on mobile today so flipping to other posts is difficult.

This feels more (much more) like a bug than a needed feature. You’ve posted in a community board where we request Capture One consider additional functionality for Capture One down the road. We also request support from fellow users. Bug reports need to specifically go to Capture One support at https://support.captureone.com/hc/en-us/requests/new. Select Report a Bug from the drop down.

If you haven’t opened a support ticket there, I strongly encourage you to do so.

Comentarios