Applying a specific lens profile

IMPORTANT: The Lens Correction tool works with RAW files only. See the list of camera models and RAW files support in Capture One.

When Capture One detects a lens model with a correction profile in the database, the profile is selected and, typically, chromatic aberration and distortion correction adjustments are automatically applied.

If the lens model has not been detected, follow the steps below to locate the profile manually or to select a profile for a similar lens. To manually apply correction, proceed with the step below. 

1. Go to the Ottica tool tab and select the Correzione Ottica tool.
   
   
   
   
2. Select an image from the browser and choose a specific lens from the Profilo drop-down menu. A selection of the most suitable lens correction profiles can be found under the Lenti Raccomandate heading or select one available from the list. See the list of lens profiles supported in Capture One.
   
   
   
   
   
3. Once a lens is selected, a checkmark will appear in the Chromatic Aberration check-box and Capture One will automatically apply the correction based on the lens profile.
   
   
   
   
4. If the image still shows some chromatic aberration, click the (...) icon and select Analizza to start Capture One's built-in analysis and correction algorithms. This will nearly always result in improved correction of chromatic aberration as the adjustment is based on the actual lens (and image sensor) used during capture.
   
   
   
   
5. Adjust the Distorzione, Caduta di Nitidezza, and Caduta di Luce sliders as necessary.
   
   
   
   
   

NOTE: The main difference between a manufacturer profile and a profile developed by Capture One for a certain lens is that we additionally correct for Caduta di Nitidezza. Thus, when the Manufacturer Profile is selected from the Profilo drop-down menu, the Caduta di Nitidezza would be greyed out.