Fill Mask Flow

Sam Akers

• 2019年07月18日 17:42

Hi All.

I've banged around on all the settings I can think of but I can't find a way to set a density for filling in a mask. I often outline where I want a mask and fill it, but when I select Fill Mask it's not the same density as the brush settings I used to draw the outline. It seems to be somewhere around the equivalent of setting the brush flow to 10 or so. Ideas?

Thanks..Sam

0

• 

  Ian Wilson

  Moderator

  • 2019年07月18日 18:10

  

  The fill in the mask will reflect the lowest value in the outline you have drawn. So if you use a soft brush, and the full-intensity middle of the outline you draw doesn’t join up all the way round, but only the softer edges, you won’t get the full intensity fill, I think. Could that be it?
  
  Ian

  0
• 

  Sam Akers

  • 2019年07月19日 08:12

  Thanks, Ian!
  
  That's the ticket! I set the brush to 100% and it fills at that density. So I can just fill at 100% and use the opacity control for the layer to vary it. I didn't realize it picked the lowest density from the brush. Excellent.
  
  ..Sam

  0

投稿コメントは受け付けていません。