Image darkens when adjusting
I have upgraded to Captureone 20. My images are stored on an external drive connected via USB I have encountered the following-
1 When I disconnect the drive and go into Offline mode the image in the Viewer darkens by about 5 points although none of the sliders have been moved. The image lightens again by about the same amount when the drive is reconnected.
2 With the drive connected the image in the Viewer darkens for a second then re adjusts whenever I click on but don't move any of the sliders within the HDR/Exposure panels. When moving the sliders the image darkens again and then re adjusts to the new value. Its quite distracting to have this constant flickering of the image being edited when the drive is connected.
Hardware acceleration set to auto or never makes no difference
This was not an issue in Captureone 12 and nothing has been changed on my setup.
Any help/suggestions would be appreciated
Thanks
Frank
1 When I disconnect the drive and go into Offline mode the image in the Viewer darkens by about 5 points although none of the sliders have been moved. The image lightens again by about the same amount when the drive is reconnected.
2 With the drive connected the image in the Viewer darkens for a second then re adjusts whenever I click on but don't move any of the sliders within the HDR/Exposure panels. When moving the sliders the image darkens again and then re adjusts to the new value. Its quite distracting to have this constant flickering of the image being edited when the drive is connected.
Hardware acceleration set to auto or never makes no difference
This was not an issue in Captureone 12 and nothing has been changed on my setup.
Any help/suggestions would be appreciated
Thanks
Frank
0
-
See the 'Image Blurring' thread. -1
Post is closed for comments.
Comments
1 comment