Skip to main content

⚠️ Please note that this topic or post has been archived. The information contained here may no longer be accurate or up-to-date. ⚠️

Select individual source points in the same heal/clone layer

Implemented
Thomas Kyhn Rovsing Hjørnet
Top Commenter

It would be very useful if you could select individual source points in the same heal/clone layer.

6

Comments

6 comments

Date Votes
  • Official comment
    Lily

    Thank you for your feedback on Capture One.

    Your comments and suggestions were forwarded to the Product Management team from Request #19121.

    Watch this video (live stream from May 5) on the upcoming tools and features in Capture One - https://www.youtube.com/watch?v=-E8OsQrAOPk

    Selecting different source points would be possible within the same Heal/Clone layer.

  • BeO
    Top Commenter

    If I have to heal something I also often run into the problem that one source point is not sufficient.

    However, how should the user interface look like if you would have the option to select different source to target vectors, should each mask pixel have a different color depending on the vector it belongs to? Or you select a vector (or source point) and only the associated pixels of the mask are shown?

    I use two layers, seldom three, for me that  works quite ok.

    Regards

    0
  • Thomas Kyhn Rovsing Hjørnet
    • Edited
    Top Commenter

    It would be fine, at least for a start, if each source/target point pair looked like the first such pair as it is now.

    0
  • BeO
    Top Commenter

    And if you hit keyboard M? All pixels red? I think I wouldn't use this feature then but create separate layers to have better control.

    0
  • Thomas Kyhn Rovsing Hjørnet
    Top Commenter

    I'm sure there are better ways of doing it. I just want to be able to chose individual target/source points without having to create a new layer every time.

    0
  • BeO
    Top Commenter

    Well done. It's nicely implemented.

    1

Post is closed for comments.