Normalize - please explain

Firstly I apologise as this post is for CO11 but there no longer appears to be a section for older software. The question is probably general enough for CO11 & CO20.

Heres the history. A few months ago I asked a question on here regarding slight colour shifts between shots. I shoot wine and between exposures (all shot within less than a minute) there was sometimes a colour shift. It would be apparent on pale and off white bottle labels. Nothing would change within the camera or CO settings but the image would have a colour shift. CO would show each exposure as the same white balance. After some forum answers and a bit more digging it turned out that flash heads have too much variation in their flash. I could get new heads but to replace everything would be a significant cost.

One of the forum responses mentioned Normalize. From reading about it, to me it would appear to be a setting recipe rather than pulling subsequent exposures to match a specified exposure. Is that the case or is it the golden bullet I'm looking for?

Heres hoping!

Comments