Cropping and Processing to desired size
Sorry to sound a little simple here, but I can't figure out the easy way to do what is probably an easy operation.
Say I have several images, and I crop some of them to 5 x 7, and the others to 7 x 5 (some horizontal , some vertical).
I can't figure out how to set up the Process tab so I can process both sizes at the same time.
I am selecting the horizontal ones and telling CO to process them at 7'' wide. Then when that is done, I am selecting the vertical ones, and telling CO to process them 5'' wide. This gives the desired results, but seems like the hard way to go about it.
Say I have several images, and I crop some of them to 5 x 7, and the others to 7 x 5 (some horizontal , some vertical).
I can't figure out how to set up the Process tab so I can process both sizes at the same time.
I am selecting the horizontal ones and telling CO to process them at 7'' wide. Then when that is done, I am selecting the vertical ones, and telling CO to process them 5'' wide. This gives the desired results, but seems like the hard way to go about it.
0
-
Mike,
You can Process to Size or you can Apply a Crop to images.
Once you set a crop on an image, this information gets written to the
.C1w file as well. You can set crop on 1 image and Apply to others selected.
You can have various crops established within same Session.
Once done, All can be sent to Batch queue together for processing.
Don't check the Width:
If you are printing to Size, then you will have to Batch the 5x7 and 7x5s separately.
Regards,
k c0
Post is closed for comments.
Comments
1 comment