7.1.2 apply adjustment not WORKING

rave81

• June 06, 2013 04:14

I updated my capture one to 7.1.2, I noticed big improvement on its speed however the apply adjustment is not working.

When I copied the adjustment I made and paste it on another image files, it doesn't apply it.

I've restarted it and clean install the 7.1.2 but same problem occurs.

So what is the best solution with this problem?

0

• 

  Paul Steunebrink

  • June 06, 2013 07:58

  Have you checked that "Edit All Selected Variants" is switched ON?

  0
• 

  H. Cremers

  • June 06, 2013 10:54

  The OP may be on to something. I had "Edit All Selected Variants" set to ON, but edits wouldn't copy. That is, with the designated buttons. Using Copy and Apply from the menu did work, but then i had to manually tick the desired edit i wanted to copy and apply.
  
  I unselected the setting and low and behold, i select my primary variant and the secondary and press the copy arrow and then SHIFT+apply arrow and it works!
  
  Maybe this could be a check for the OP.

  0
• 

  Permanently deleted user

  • June 15, 2013 13:31

  I think I have to join that issue:
  
  Yesterday a made a lot of picts with Sony A900, the first 1/3 in Sony RAW, the rest of the some 160 pictures in JPG (highres). This bunch of picts I importet into CO 7.1.2
  
  After I edited the raw I went over the jpg, but all the sudden Capture One refused to apply my settings! There was only a error-"boing" on my mac. After restarting and several crashes of CO, restarts of my Mac Pro (10.6.8), all the imported JPG showed a crossed-out pencil!
  
  This until now, 2 days of tinkering. I'm severely cursing, cause I shall deliver a web gallery to the employing party.
  
  Mac Pro, 10.6.8; 8 GB RAM, Open GL deactivated
  using referenced catalogue
  
  Johannes

  0
• 

  H. Cremers

  • June 15, 2013 20:11

  Make sure you've set the flag to allow JPEG editing (it's somewhere in the preferences).

  0

Post is closed for comments.