5dII and v6.4.4 on OS 10.8.2 tethering not working
Hi,
I rebuilded my computer (reinstalled all software clean) and installed 6.4.4 (had too many problems with v7.x). I just had my cameras coming back from Canon (sensor cleaning) and the tethering is not working anymore.
Prior to rebuilding the computer and cleaning, it was working fine. Same versions of the software. When I connect the camera, I get the activities window with the message "Attaching camera - Estimating time remaining". And it just stays there. It never attaches. I tried different cables. Also, I tried it with LR4 and it works. Any suggestions?
Capture One build 60680 (v 6.4.4). Canon firmware 2.1.2.
I rebuilded my computer (reinstalled all software clean) and installed 6.4.4 (had too many problems with v7.x). I just had my cameras coming back from Canon (sensor cleaning) and the tethering is not working anymore.
Prior to rebuilding the computer and cleaning, it was working fine. Same versions of the software. When I connect the camera, I get the activities window with the message "Attaching camera - Estimating time remaining". And it just stays there. It never attaches. I tried different cables. Also, I tried it with LR4 and it works. Any suggestions?
Capture One build 60680 (v 6.4.4). Canon firmware 2.1.2.
0
-
Two suggestions:
1. Post in the Capture One 6 forum
2. There you can find this workaround in a sticky thread on top of the thread list (it is a known issue, solved in CO 7.0.2)
viewtopic.php?p=59346#p593460
Post is closed for comments.
Comments
1 comment