EIZO Calibration
While it works perfectly fine with EIZOs ColorNavigator6 there just doesn't seem to be any way to get my CG2730 to work with the calibration tool in Capture One.
A white bar appears where it should (right beneath the sensor) there's just nothing happening except for some faint sounds coming from the place where the sensor is. Then there's an error message and after a minute or so it stops.
As I said, regular calibration works just fine but since this tool is available I wanted to give it a try. Am I doing something wrong? Has anyone every got it to work?
And furthermore: what is the precise use of it? Should it deliver even more precise colours or accurate ICC profile displaying?
A white bar appears where it should (right beneath the sensor) there's just nothing happening except for some faint sounds coming from the place where the sensor is. Then there's an error message and after a minute or so it stops.
As I said, regular calibration works just fine but since this tool is available I wanted to give it a try. Am I doing something wrong? Has anyone every got it to work?
And furthermore: what is the precise use of it? Should it deliver even more precise colours or accurate ICC profile displaying?
0
-
Hi
Before anything else, I believe it could be a good idea to refer to release note / online help:
The following Eizo monitor models are supported:
24-inch.
CG245W, CG246, CG247, CG247X, CG248 (UHD 4K)
27-inch.
CG275W, CG276, CG277
31-inch.
CG318 (DCI 4K).
If you want to add a feature request to have your monitor supported then you can do so by submitting a support case with us at Phase One.
Http://support.phaseone.com0 -
Ah, okay, so it's really specific! I thought if it was enabled it would work with the one I'm using. Thank you for the clarification. 0
Post is closed for comments.
Comments
2 comments