Capture One 12.1 Preview Exclamation on update

Eduardo Lopez Robledo

• June 15, 2019 11:58

Hi,

I have updated from the last capture 12.0.x version to 12.1 and when i open a session, i must update also session to capture 12.1 compatibility. When i do that, i have much previews with an exclamation and i can't work with it.
Theese shots are made with a tethered Canon EOS R.

Also im trying to create a new session to import Raws but capture one cant do it. I cant import with lightroom but in capture one importing folder, raws dont apear to be seleccted. I can import new raws but not that.

Could you help me? Thanks.

Here is a screenshot:

0

• 

  Permanently deleted user

  • June 15, 2019 16:33

  [quote="NNN636909217628212595" wrote:
  
  I have updated from the last capture 12.0.x version to 12.1 and when i open a session, i must update also session to capture 12.1 compatibility. When i do that, i have much previews with an exclamation and i can't work with it.
  Theese shots are made with a tethered Canon EOS R.
  

  
  
  Were the pictures with exclamation adjusted with 12.0 ? If yes, the only way to recover the adjustments done with 12.0 is to go to the folder containing your .cosessiondb, and you'll find a .cosessiondb.backup. You suppress the .backup extension and you should be able to recover your adjustments. This is the recipe given by some users faced with the same issue, but I didn't try it as I work in catalog mode.

  0
• 

  SFA

  • June 16, 2019 21:46

  [quote="NNN636909217628212595" wrote:
  Hi,
  
  I have updated from the last capture 12.0.x version to 12.1 and when i open a session, i must update also session to capture 12.1 compatibility. When i do that, i have much previews with an exclamation and i can't work with it.
  Theese shots are made with a tethered Canon EOS R.
  
  Also im trying to create a new session to import Raws but capture one cant do it. I cant import with lightroom but in capture one importing folder, raws dont apear to be seleccted. I can import new raws but not that.
  
  Could you help me? Thanks.
  
  Here is a screenshot:
  

  
  
  Are these all new files captured during a tethered session?
  
  Did you use any camera(or manufacturer) specific settings that might be applied to CR3 files? Did you use the same settings successfully in Capture One 12.0.x?
  
  Have you checked that the Preferences are still enabled for tethering to Canon to be enabled (I seem to recall that it not set the camera does not connect but it is not something I have looked into for a while and I have yet to install 12.1 so I cannot test it.
  
  Check the Capture One release notes for any comment about known processing constraints for your camera.

  0

Post is closed for comments.