Clone/Health layer: copy one fixed point to multi areas

Phong Le

• June 24, 2016 07:05

Hi All

Could some one guide me how to copy fixed one point in Clone/Heath layer to multi areas without slide the source (when I use the brush, the source point slides relative with the destination).

Thank you
Phong

0

• 

  PhaseoneUser55657

  • June 24, 2016 11:27

  Simple use multiple layers.
  
  Robert

  0
• 

  Permanently deleted user

  • June 24, 2016 13:06

  Hi,
  
  the usage of muliple layers with one spot corrected on each as the previous poster suggested is one possibility.
  
  The other is that you can define on one layer several correction points. But only one source point for the correction to be done, this is, the direction and distance to the source spot from where the correction information is taken would then be the same for each corrected spot on that same layer.
  
  This may work well for example for the correction of dust spots in a clear sky when the proper dust/spot correction tools doesn't provide the desired result (for example when such a dust spot is close to other image's content so the performed merging would provide an unpleasant look).
  
  The limitations for this approach however are if each spot to be corrected needs a different definition for the source. Or when source and destination for several spot to be corrected overlap because the source picks always the original image content of the selected spot - and not the corrected content of a possible neighbour correction on the same layer.
  
  Sounds more complicated than it is but simply trying it out will show you what works and what doesn't work.

  0
• 

  Phong Le

  • July 01, 2016 12:11

  Thank you all
  
  Look like the multi layers is the best solution now.
  My problem is the backdrop in studio is very very bad, I have to clean it by software.
  
  Best regards
  Phong

  0

Post is closed for comments.