Ian Crook
- Total activity 27
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 5
Activity overview
Latest activity by Ian Crook-
Ian Crook commented,
Thanks - after the original post my Surface arrived and I have a similar experience with Capture One. Would be nice if it ran faster but.... The other thing I have discovered is that Epson hasn't p...
-
Ian Crook created a post,
Capture One Compatibility with MS Surface Pro 11 Arm Processor
I have to replace my Surface Pro 8 tablet, which uses an Intel i7 processor. The replacement Microsoft tablet - the Surface Pro 11 - uses the Snapdragon X Plus processor produced by Qualcomm, which...
-
Ian Crook commented,
Thanks for the comments. I will open tickets and see what happens. Stay tuned!
-
Ian Crook commented,
So I have spent about 5 hours on the phone with Epson (50% of the time listening to Muzak) and got nowhere. I finally managed to get to third level support, and was asked to install Epson Layout, a...
-
Ian Crook commented,
Thanks. I will check the updates. My next stop is to call Epson again - the challenge is to get past the first level support people, who told me the problem was MS Word/Photoshop/Capture One. Once ...
-
Ian Crook commented,
I update my Windows 11 OS as the updates come out, and according to my system there have been monthly updates. I'm running Capture version 16.3.7.1979 (i.e. perpetual license version). Since I hav...
-
Ian Crook commented,
Thanks for the comments. I will have to figure out how to make this work. The real mystery to me is why this is suddenly occurring. For over seven years, using my P600, I could print an image prin...
-
Ian Crook commented,
One other interesting data point - I printed a 13x19 photograph this evening for an exhibition, using Epson Hot Press paper; this paper uses the manual feed tray at the front of the printer. It pri...
-
Ian Crook commented,
I use a Nikon Z8, which has a 3:2 sensor. Below are images I just took, which I think followed what you were recommending: I set the margins to 0, which results in the image being full from a heigh...
-
Ian Crook commented,
The other question I have is this: I just printed the same page on 8 1/2 x 11 using the same approach - set the borders and the cell size sets itself, and it printed perfectly, with the correct bor...