Richard801

  • Total activity 23
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 4

Activity overview

Latest activity by Richard801
  • Richard801 commented,

    Hi Paul,Just got in from a long day and will not be able to test it out. I'll lbe shooting on location all week so hopefully at some point this week or the week end I will try out your suggestions ...

  • Richard801 commented,

    Hi Paul,Just going out to shoot a job and will try later this evening.

  • Richard801 created a post,

    DCIM jpegs not importing

    Just came back from St. Lucia from a shoot and decided to also take some snaps with my Canon point & shoot camera. C1 6.2.2 not properly importing the DCIM jpeg images into selected folder. It scan...

  • Richard801 commented,

    Finally broke down and got a new 5D MK II. Hooked it up and voila! it works! Sometimes wasting time or trying to initiate another hack solution doesn't pay off. Still, I hope that Canon will still ...

  • Richard801 commented,

    Hi Drew,Hope that you had a great Christmas.As per my initials trials with Lion and C1 6.3.2 and trying the Hot Folder I still cannot initiate the camera. I've gone through the steps outlined, as p...

  • Richard801 commented,

    Salute Nicolas,I almost always shoot tethered but that's another story.Thanks for trying and good luck with Santa Klaus. Perhaps someone else will chime in after the Christmas festivities.Drink lot...

  • Richard801 commented,

    Hi Nicolas,So I installed EOS 2.8.1 and went through all the steps for C1 enabling the hot folder but my camera is still not seen It still hangs when I try to capture an image.Any thoughts? I also ...

  • Richard801 commented,

    Thanks Nicolas,I'll give it a try.Also, Joyeux Noel.

  • Richard801 commented,

    So I went on the sites and tried to find and download 2.8.1 but got the run around. Couldn't find a link anywhere for it. Does anyone have a direct link for this ?Cheers,Richard

  • Richard801 commented,

    Hi Paul,Thanks for the info. I've been shooting on location so that's why I haven't responded sooner. I'll try that method over the next couple of days and see if it works.Thanks,RichardP.S. I also...