Thomas Schneider
- Total activity 118
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 17
- Subscriptions 26
Comments
Recent activity by Thomas Schneider-
Perhaps it would be good in such a case to show a hint (without ok button) that nothing could be added. That way you could be sure that the area has been added and not have to check the mask again ...
-
Frank Schroeter, I had a similar problem relating to the load on resources: I running C1 16.5.2 on a Windows 11 Ryzen 7 5700U with a internal Radeon Graphics and I am quite satisfied with the speed...
-
Thanks for your testing Ian. (it's funny, I used a similar gray heron picture for testing). The duration should be just as short with my computer as with your setup. I agree with you that it's not ...
-
Not really. If I switch the acceleration to never, you can observe the effect a little better, as the calculation now takes a little longer. Doesn't it show up for you? (best see, if you you zoom t...
-
Thanks for your answer Ian. I have experimented with the settings, but it does not seem to be due to the speed. If you continuously zoom into the image (with the mouse wheel), the preview always re...
-
I have found the solution: There were 2 recipes with the same name but different settings. I suppose this resulted from updates, some of which contained and installed new recipes. It was curious th...
-
Mister Tolley Yes, on C1 version 12 I had the same problem. Then I switched to the Nikon version 21. This version seems to behave as Ian Wilson describes. Version 16.5 again forgets the last recipe...
-
Hi Ian, I am using the latest Capture One 16.5.1 on a Windows 11 System. I use custom recipes (only one at once), but it never stays on the last recipe. Every new session switch to the TIFF recipe,...
-
Yes, it is perpetual.
-
Even though i have not yet received confirmation, the limit of 100 spots still seems to exist. The AI supported dust removal is really good, just a pity when it stops at 100 points. I develop an AI...