Bill_H
- Total activity 26
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 8
Activity overview
Latest activity by Bill_H-
Bill_H commented,
Did you get a chance to see the video? It is more a 'walk-through of the functionality' and may be what you are seeking.
-
Bill_H created a post,
What's REALLY most important ...
Reading the forum I see many people complaining about many things, and I agree that things like the interface changes, the cache location, even removing the mouse-scrolling are disappointing. I've...
-
Bill_H commented,
Tom, I just went thru a full support case cycle and right now it is taking them a while to respond so probably you just have to be patient (I'm sure that's not what you want to hear).For specifics,...
-
Bill_H commented,
lpcd2001, C1 3.7.7 works with the 1D M III except for these two things: 1) the High Tone Priority custom function is not recognized, and 2) there's a small strip of garbage pixels left at the botto...
-
Bill_H commented,
John Malloy wrote: "Hey, Bill....I'm gonna be testing Highlight priority soon....can you confirm wether Adobe accommodates HP"Yes, ACR interprets the custom function correctly and the exposure is r...
-
Bill_H commented,
Just to update this in case other 1D Mark III users have this problem, apparently the problem occurs if you set Custom Function II-3 (Highlight Tone Priority) since COne doesn't recognize this CF a...
-
Bill_H commented,
banzai, in re-reading this thread I see you had suggested it might be this CF in your first post and I should have tested this after your post, so you deserve credit for figuring it out too.I sent ...
-
Bill_H commented,
John, you solved it! Thanks, I'll fill out an updated support case and send it to Capture One, they will be thrilled to know the 'solution'.I just re-shot the grey-card/white-card again and with t...
-
Bill_H commented,
We are using both 3.7.7 and 4.0 and there are no problems.
-
Bill_H commented,
I'm getting the same message ... is this a problem on my end (say my firewall settings or something like that) or is Phase One just overloaded for a bit?Anyone know?