Mike Bailey
- Total activity 31
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 9
Comments
Recent activity by Mike Bailey-
Thanks for the tip... that's quicker, but like you say, an option in a settings dialog like for the other noise reduction settings would be best so that default settings can be changed globally, th...
-
Thinking it should be a simple matter of saving the default film curve file for my camera, then copying the film extra shadow curve to that name, I tried this, but apparently the internal name is a...
-
Paul,Good idea... I normally do not crop prior to development, so this never occurred to me. The preview, zoomed or not, does not show the problem, and trying to crop several lines off one side i...
-
Thanks Paul... And to answer Janne, it was firmware version 1.0.5, the latest. I also reproduced the same results using a CR2 file kindly posted on outbackphoto.com from an earlier version (1.0.3...
-
Keith,Thanks... I had gone ahead and created a case # and received a reply pretty much stating what you said here, though I am downgrading from SE to LE since PRO does not have any extra features t...
-
I've found that the lockup while scrolling the thumbnails can happen even when nothing is being processed. The task manager show memory usage by C1 Pro v3.7 at 99% when it locks up. There is some...
-
Juli, RF,3.7 Pro and 3.6 SE did the same for me, i.e. hang, whenever I would open a new folder of raw images and the first pass was just getting started generating the preview files and I tried to ...
-
Ulf,Thank you for your response. I'm not sure what you mean in your last sentence about longer integration time and the algorithm not kicking.Out of curiousity I checked to see what C1 was doing (...
-
For me, the default is 22 on a 20D at IS0 400. This is way too high and way too much detail gets lost, for instance shooting a bird will easily plasticize the feathers at this setting unless for e...
-
Keith,What I'm referring to isn't a result of sharpening, at least any that I applied, as this reference is to output created with shaprening output not enabled. Perhaps plastic is too inflammator...